5 Slide the spool guide onto the right side of the spool and press the
guide tightly against the side of the label roll, leaving no gap
between the roll and the spool. See Figure 6.
NOTE To ensure proper feeding of labels during printing, the label roll
must fit snugly against both sides of the label spool, with no gaps.
Figure 6
6 Insert the label spool into the slot in the printer cover with the labels
extending from underneath the roll. See Figure 7.
7 Align the left edge of the label with the left edge of the label feed slot
and insert the label into the slot. See Figure 8.
The printer automatically feeds the label, stopping at the beginning of
the first label.
Figure 7
If the printer does not feed the labels, make sure the
first label is fully inserted and then press the form-feed
Slide label
guide against
labels
button.
Align labels
against left edge
If the first label on the roll is not a full label, press the
form-feed button to eject the partial label.
8 Slide the label guide to the left until the label guide
aligns with the right edge of the label. See Figure 8.
Make sure that the label guide does not pinch the label.
Figure 8
9 Carefully lower the top cover.
6
