TM
GALILEO 9’ X 7’
MODEL 2000001126
To Set Up Tent (continued)
Before you begin
8. Assemble the
interlocking
Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
shock-corded,
gray, shorter pole.
9. Slide pole through
sleeve on front of
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
• For best results in windy conditions, position end of tent into
the wind.
tent. (Fig. 5)
Fig. 5
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
10. Pull down on pole and
insert into center pin
location on side of tent.
(Fig. 6)
Parts and Components
11. Go to opposite side of
tent and gradually apply
pressure to the pole to
form an arch. Insert the
pin into the pole.
Description
Part Number
Main Poles (2)
Front/Awning Poles, Gray (2)
Rainfly
9240-1221
9240-1231
9240-1241
Fig. 6
12. Attach frame clips along edges of tent
to frame poles. (Fig. 7)
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface with the
door facing the desired direction. Unzip door.
2. Assemble main tent poles by interlocking both longer, black
shock-corded, poles.
Fig. 7
3. Insert black poles through sleeves in top of tent forming an
“X” as shown. (Fig. 1)
To Attach Rainfly
1. Assemble remaining interlocking
shock-corded rainfly pole (gray pole).
2. Drape rain fly over tent. Make sure
end with two flaps is centered over
the door.
Fig. 1
3. Slide gray pole through sleeve in
rainfly. (Fig. 8)
Fig. 8
4. Insert one end of each rainfly pole
into remaining pin in front corner
of tent. Gradually apply pressure
to other end of pole to form an
arch & insert into other front pin.
(Fig. 9)
4. Insert one end of each black pole into
pins in rear corners of tent. (Fig. 2)
Fig. 2
Fig. 9
5. Go to opposite end
of each pole and
5. Hook clips on elastic loops of
rainfly onto rings on all four
corners of the tent. (Fig. 10)
gradually apply
pressure to the pole
forming an arch.
Insert the pin into
the pole end at the
tent corners. (Fig. 3)
Fig. 10
6. Secure rainfly with velcro hook & loop ties located on
6. Stretch corners of
Fig. 3
underside of fly. (Fig. 11 & 12)
tent until floor is taut
then hammer stakes
through loops to
secure.
7. Attach frame clips along edges
of tent to frame poles (Fig. 4)
Fig. 11
Fig. 12
Fig. 4
(continued on other side)
|