TM
KVIKA TENT 8’ X 8’
MODEL 2000001059
To Set Up Tent (continued)
Before you begin
Read all instructions before set up.
7. Attach frame clips along edges
of tent to black main poles
(Fig. 5)
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
8. Assemble first interlocking
shock-corded, gray pole.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
Fig. 5
• For best results in windy conditions, position end of tent into
the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
9. Slide the gray pole through sleeve on front of tent. (Fig. 6)
Parts and Components
Description
Part Number
Main Poles, Black (2)
Side Poles, Gray (2)
Rainfly
5010000360
5010000361
5010000362
Fig. 6
To Set Up Tent
10. Pull down on pole and insert into
center pin location on side of tent.
(Fig. 7)
11. Go to opposite side of tent and
gradually apply pressure to the
pole to form an arch. Insert the
pin into the pole, then drive stake
through metal ring to secure.
12. Attach frame clips on both sides
of tent to gray pole.
1. Unfold tent and spread out on a clean, level surface with the
door facing the desired direction. Unzip door. (Fig. 1)
Fig. 1
Fig. 7
Door
To Attach Rainfly
2. Assemble main tent poles by interlocking both longer, black
shock-corded, poles.
3. Insert black poles through sleeves, with the black seams, in
top of tent forming an “X” as shown. (Fig. 2)
1. Drape rainfly over tent with vestibule centered over the door
on the front of tent (Fig 8).
NOTE: Hook and loop
fasteners, located on
seams of underside
of rainfly, should be
centered over black
Fig. 8
Fig. 2
Sleeves with
black seams
and gray poles.
Vestibule
on Rainfly
Front on Tent
2. Secure rainfly with velcro hook
& loop fasteners, on underside
of rainfly, around black poles at
the back of tent and gray pole
on both sides. (Fig. 9)
4. Insert one end of each black pole into
Fig. 3
pins in front corners oftent. (Fig. 3)
Fig. 9
5. Go to opposite end of each pole and gradually apply pressure
Sleeve
in Rainfly
3. Assemble remaining interlock-
ing shock-corded gray pole.
4. Fold back vestibule on front of
tent to locate sleeve on under
side of rainfly. (Fig. 9)
5. Slide gray pole through sleeve
in rainfly. (Fig. 9)
to the pole forming an arch. Insert the pin into the pole end
at the tent corners.
(Fig. 4)
6. Stretch corners of
tent until floor is taut
then hammer stakes
through loops to
secure.
Fig. 10
Fig. 4
(continued on other side)
|