Before using your headset
Check the accessories
Charge your headset
Thank you for purchasing the Samsung Bluetooth
Mono Headset WEP180, we hope you will be
delighted with its operation.
Take a moment before you get started to
familiarize yourself with your new headset.
Make sure you have the following items with your
headset:
Charge the headset's battery fully before using
the headset for the first time.
3
Remove the travel adapter from the headset.
Quick Start Guide
Bluetooth® Headset
WEP180
Get connected in 4 quick steps
NOTES:
Travel adapter, User’s Guide, 1 ear hook
1
Plug the travel adapter into the jack on the
headset.
• The headset cannot be used while charging.
• Use only a Samsung-approved charger or adapter.
Samsung
NOTE:
The items supplied with your headset and the accessories
at your Samsung dealer may vary, depending on you
country or service provider.
Multi-Function
Adapter jack
button
• Bluetooth version: 2.0 (compatible with devices of
Bluetooth version 1.1 or higher)
• Supported Bluetooth profiles:
- Headset profile
Charge your headset
Earpiece
Put your headset in pairing mode
Turn on Bluetooth on your phone and
pair with headset
2
Plug the travel adapter into the electrical
outlet.
Indicator light
Volume control
- Hands-free profile
• Charge the headset until the red light on the
headset turns to blue.
buttons
Microphone
Test and use
• The headset will be fully charged in
approximately 2 hours 30 minutes.
Start here
Put your headset in
pairing mode
Turn on Bluetooth on your
phone and pair with headset
Test and use
Your phone and headset are now paired and
ready to make and receive calls. To confirm
they are operating properly, make a call:
Before you can use your headset, you must pair it
with your phone.
1
Set your Bluetooth phone to discover the
headset by following your phone's guide.
Using your WEP180
Headquarters:
1301 East Lookout Drive Suite 150
Richardson, TX 75082
1
Place the headset over your ear.
See Wearing the headset on the reverse
side of this guide.
Typically, the steps involve going to the Settings,
Connection, or Bluetooth menu on your
phone and then selecting the option to discover
Bluetooth devices.
1
2
Ensure that the headset is off (see Turn
headset on/off on the reverse side of this guide).
See Features and Functions Guide
on the reverse side of this guide
for information on using your
WEP180.
Internet Address:
accessories
Press and hold the Multi-Function button until
the indicator light turns on in blue
(approximately 8 seconds).
2
3
On your phone, make a call to the number
you want.
Your phone will find the Samsung WEP180
headset. your headset will be displayed as
Samsung WEP 180/185.
If your phone and headset are successfully
paired, you will hear ringing on the headset.
Customer Care Center:
1-888-987-4357
2
3
Select your headset.
After you have successfully paired your phone
and headset, you do not need to repeat these
initial setup steps each time you use the
headset.
When the phone asks if you want to pair with it,
confirm by selecting Yes or OK.
4
Enter the headset passkey or PIN, 0000.
Guide No.: GH68-12459A
09/2006. Rev. 1.0
|